Gear Flank Analyser

Gear Flank Analysing allows to scan all tooth flanks within a few minutes and is suitable for large batches.

• Special method based on the single flank gear inspection method (contact ratio < 1)
• Calculation of the complete tooth flank surfaces
• Information about profile, helix, pitch and runout of all teeth and along the whole tooth width
• Simulation of Single Flank Test including Fourier analysis
• Robust design for the shop floor use
• Designed for approximately 60 to 100 measurements per day
• Evaluation by FRENCO Software FGI RS

Product Brochure Product Video

Method based on Master Gears

• Master gear is matched to that of the workpiece to be inspected
• Short reaction time
• High economic efficiency for large batches without changeover

Method based on Disc Roll Master

• Disc roll masters are custom made for geometries within a family of parts
• Number of measuring planes selectable (direct influence on measuring time)
• Workpiece held between two centres